Malcom Northman asked on the FB page if someone could provide a picture of the mounting bracket for the MT Propeller sensor. Chad Faykus shared following photo’s with us:
Malcom shared this picture of the mounting bracket up close:
Chad had added following additional comment:
Here are the pics as promised. I started out with a peice of 3×3×3/16 angle. There is a slight bend where it mounts to the psru that will obtain the 2degree angle the brushes need to be at on the transfer rings. Let me know if you need sims and I’ll take some measurements tomorrow.
Additionally, Malcom asked if direction of thrust mattered as he was considering mounting the sensor on the other side of the PSRU. According Chad there will be not too many alternative mounting positions available, safe this one, as this spot seems to be the only spot with sufficient space.